myStrom STECCO Manuel D'installation page 4

modulo STECCO
®
Istruzioni d'installazione (retro)
IT
Installation manual
EN
Installation
Download the myStrom App
Launch App
Open a free account or connect with your
existing one.
Connect STECCO
Connect your new STECCO to the power outlet.
Add STECCO
Select «Add device» in the menu to add your
new STECCO.
Setting the optimum operating mode
After installation, select STECCO > Settings >
Configuration > 2 channels
All Done
Anzeige, Modi, Reset
LED
Off STECCO is plugged off
White WLAN connection OK and
connected to the myStrom
service
White blinking WLAN pairing mode (WPS)
Red Start/Boot mode
Red blinking Connection in progress
Red short blinking Access Point mode
WPS/Reset Button (push with paper clip)
WPS Connect STECCO to a WLAN network
(DSL router or Access Point) – press for
2 sec.
Condition – DSL router/Access Point
supports WPS.
Reset Resets STECCO to its factory settings.
Any connection to the WLAN network
will be lost – press for 10 sec.
FAQ & Support
STECCO not working?
• Restart STECCO
Simply unplug and plug it in again.
• Plug STECCO close to your DSL Router
If the LED lights up in white, STECCO works
perfectly and could have suffered from a weak WiFi
signal in its previous location.
• Reconnect STECCO
Activate WPS first on your Router, then on your
Controller.
Further help & contact form
www.mystrom.ch/support