Installing The Strainer - Presenza QK81C Manuel De L'utilisateur

Installation (continued)

INSTALLING THE STRAINER

NOTE: If you are installing a garbage disposer (not
supplied), do not install the strainer.
- Apply plumbing putty or silicone sealant (not
included) to the top side of the drain opening.
- Insert the strainer body (15) into the
drain opening and press it down until it is
evenly seated .
- Assemble the rubber gasket (16), fiber washer
(17) and strainer locknut (18) onto the strainer
body (15) from underneath the sink. Hand
tighten the strainer locknut (18) until it is snug.
Do not overtighten .
- Insert the plastic flange (19) into the flange-end
of the tailpipe (20) (not supplied) then secure
the tailpipe to the strainer body using the
connecting nut (21). Tighten the connecting nut
(21) until it is snug. Do not overtighten.
- Remove excess sealant from around the
drain opening .
DRAINAGE
The tailpipe (not supplied) previously installed to the drain can now be connected to your household plumbing. In
some cases, your household plumbing will have to be modified to ensure proper drainage. If so, please consult a
licensed plumber to complete needed modifications
SUPPLY LINES (NOT INCLUDED)
Connect the supply lines to your home's water supply as per manufacturer's
instructions .
Open the hot and cold water supply valves and check to make sure they have
been installed to appropriate inlet ports . Check for leaks . Run hot and cold
water uninterrupted for about one minute to remove any residue from the lines .
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Sink (A)
.
13
Strainer Basket (22)
Strainer Body (15)
Sealant
Rubber Gasket (16)
Fiber Washer (17)
Strainer Locknut (18)
Plastic Flange (19)
Tailpipe (20)
(not supplied)
Connecting Nut (21)
Fig . 13
CONGLOMKB .COM