Alarm Messages - Sabiana CB-touch Mode D'emploi

English

Alarm messages

Display
t1 t1
t3 t3
o o
Er Er
Description
Air temperature probe T1 faulty or not connected
Frost alarm
The temperature detected by the temperature probe drops below 5°C.
After 3 minutes in this situation the cooling symbol flashes.
Minimum probe signalling T3
If installed, if the T3 probe is not satisfied, after 3 minutes "t3
with the display of the setpoint.
In addition, depending on the mode you are in, the relevant symbol flashes.
Wi-Fi connection loss (connection problems)
In case of Wi-Fi connection loss, the control will send the message "
splay.
Check the connection and the Wi-Fi router status.
Once the Wi-Fi connection is restored, the control will be connected automatically
to the network and delete the error message.
Wi-Fi connection loss (network change)
In case of Wi-Fi connection loss, the control will send the message "
display.
In case of network change and of Wi-Fi parameters reset, push the
then the buttons and
At this time the message 'yes' appears; push the button
–
button cancels the procedure.
The reset of the Wi-Fi unit parameters and of the login details will take place.
The message will disappear at the next power-on.
for 5 seconds.
14
t3" flashes alternating
Er
" on the di-
Er
" on the
M
button and
+
to confirm whereas the