Switching On The Hob; Pot Detection - Integra 5 Zone Prescriptions De Montage Et Mode D'emploi

Integra 5 zone is equipped with electronic touch sensor buttons.
First
switch on the hob followed by the desired cooking zone.

Switching on the hob

Press the power button
All the displays will turn on.If, after a few seconds, no other button is pressed, the hob switches
itself off for safety reasons.
Activation of the desired cooking zones
Press the button corresponding to the zone you want to use.
0 appears on the display, press + or - to select the desired power from 1 to P.
it is possible to activate plate warmer mode indicated by the symbol U by selecting the power level
between 0 and 1
P
Booster
: indicates the
essary to press the + button until you reach power 9, and then press it again.This mode will remain
active for 5 minutes, after which the system switches back to power 9.
This mode is recommended to bring water to a boil faster.
If suitable cookware is not positioned or detected on the various cooking zones, the pot detection
feature will indicate this error with the symbol "u"
Therefore, place a pot with suitable for diameter and materials on the cooking zones, as indicated
in the paragraph suitable cookware.
The cooking zone will automatically switch off after 10 minutes if no pot is detected.
Turning off the hob and residual heat indicators
Press the power button.
The light of the main switch and those of the cooking zones turn off.The hob is now off. Each
cooking zone has a residual heat indicator marked with an
cooled down sufficiently.
Warning: burn hazard
Do not touch a cooking zone with the (H) indicator lit.
If a cooking zone remains switched on for too long at the same power level, the appliance auto-
matically turns it off and the residual heat indicator H appears.
Switch it on again as usual to restart the cooking zone.
The following table shows the maximum uninterrupted operating time for each power level:
FUNZIONAMENTO OPERATION
for at least 2 seconds.
mode that is available on every cooking zone.To activate it, it is nec-

Pot Detection

H
that remains lit until the zones have
25 25
GB I