INVENTOR EPC-09 Mode D'emploi page 15

NOTE:
- Button design is based on a typical model and might be slightly different from the actual one you
purchased.
- The unit can complete all the functions described. If the unit does not have the feature then the
corresponding button on the remote control will not work.
- If there are a major differences between the "USER'S MANUAL" and the "Remote control Illustra-
tion" on function description, please use the description in the "USER'S MANUAL".
- The device should comply with the local national regulations. In Canada, it should comply with
CAN ICES-3 (B)/NMB-3 (B). In USA, this device complies with part 15of the FCC Rules. Opera-
tion issubject tothe following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
- This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet that is different from the one the receiver is connected to.
• Consult the dealer or an experienced radio/TV technician for help. Changes or modifications
not approved by the party responsible for compliance could void user's authority to operate the
equipment.
15