Weber Summit 89796 Guide De L'utilisateur page 14

14
PROBLEM
Side Burner does not light.
Flame is low in "HI" position.
Push button ignition does not work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should be in
the "OFF" position.
Make sure black wire is connected between the igniter and electrode.
Make sure white wire is connected between the igniter and grounding clip.
Spark should be a white/blue color, not yellow.
1) Igniter Wire
SIDE BURNER TROUBLESHOOTING
CHECK
Is gas supply off?
The excess flow safety device, which is part
of the barbecue to cylinder connection, may
have activated.
Is the fuel hose bent or kinked?
Does burner light with a match?
®
.
Turn supply on.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
START/HI. Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting
Instructions".
Straighten hose.
If match lights burner, check igniter (see Sideburner Maintenance).
2) Ground wire
3) Burner
Side Burner Grate
ner Grate
Side Burner cap
rner Cap
Side Burner Ring & Head
g & Head
Igniter Electrode
Electrode
Control Knob
trol Knob
Igniter
Igniter
CURE
(3)
WWW.WEBER.COM
®