Typical Installation - Sanborn Powermate Px Mode D'emploi

Pistolet pulvérisateur universel

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Key

Description

Air hose

In-line Filter

Tee Fitting

This spray gun is shipped from the factory designed for use as a "non-bleeder", which means you must pull

the trigger on the gun for air to flow through the gun. Non-bleeder operation requires an air compressor that has a

storage tank.

Spraying Instructions

1. As a standard practice, drain water from the air

compressor tank and air lines prior to use each day

(reference your compressor operators manual for

detailed instructions). NOTE: Failure to install

appropriate water/oil removal equipment may

result in damage to the spray gun or workpiece

(see Figure 1).

2. Install a 1/4" NPT female connector (not included) onto

the air inlet port on the tool (see Figure 2). Note: Use

Teflon® Tape on all threaded connections.

3. Mix material according to the manufacutrer's

instructions, adding thinner if needed. Mixture should

be smooth and easily pourable. Lumps or foreign

objects should be removed by straining through a

suitable paint filter or cheesecloth.

4. Fill the cup no more than 3/4 full. Firmly attach the cup

to prevent air leakage. Avoid damage to the sealing

surface of the cup and the gasket—damage to these

parts will cause air leaks and prevent the gun from

spraying properly. If paint leaks around the needle pin

packing gland, tighten the packing gland nut just

enough to stop the leak but not enough to interfere

with movement of the needle pin. Apply light machine

oil to keep the packing soft and help avoid leaks.

NOTE: If using the spray gun for the first time,

fill the paint cup with thinner and spray into a

grounded metal waste container to flush the gun and cup of any impurities that may have accumulated

during assembly and shipping.

5. Attach air supply line to 1/4 NPT female connector plug.

6. Start the compressor and set the regulator to 25-50 PSI. NOTE: Be sure

there is sufficient hose connected between the gun and air supply to

comfortably reach the work surface.

This spray gun is designed to operate best at pressures

between 25-50 PSI. Never attempt to operate this spray gun at pressures in

excess of 50 PSI.

This spray gun is designed to operate in two distinct ways for different paint-

ing functions.

For use as Pressure Feed:

1. Push the button (N) so that it is extended towards the word "pressure" (see

Figure 3).

NOTE: This set up is used when spraying medium bodied, fast-drying

materials such as lacquers and fast-drying enamels.