Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11/07/2017 PK
ICE MAKER INSTALLATION
Remove Packaging Materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice maker.
Remove tape and glue from your ice maker before using.
• To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also
be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your ice maker.
Cleaning Before Use
After you remove all of the packaging materials, clean the inside of your ice maker before using it. See the
"Interior Cleaning" in the Cleaning and Maintenance section.
Installation Clearances
• This ice maker should be properly installed by qualified personnel.
• To ensure proper ventilation for your ice maker, the front of the unit must be completely unobstructed.
• When installing the ice maker under a counter, follow the recommended spacing dimensions shown. Allow
at least 4" (102mm) clearance at rear, and 1"(25mm) at top and sides for proper air circulation. The
installation should allow the ice maker to be pulled forward for servicing if necessary.
• Choose a well ventilated area with an ambient temperature range of between 50°F (10°C) to 99°F (37°C). This
unit MUST be installed in an area protected from the elements, such as wind, rain, water spray or drips.
• The unit should not be located next to ovens, grills or other high heat sources.
• Installation of the ice maker requires a cold water supply inlet of ¼" (6.35mm) soft copper tubing with
a shut-off valve.
• The ice maker requires a continuous water supply with a minimum pressure of 15 psi (1 bar or 103 kPa) and a
static pressure not to exceed 75 psi (5.2 bar or 517 kPa). The temperature of the water feeding into the ice
maker should be between 40°F (4°C) and 90°F (32°C) for proper operation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
TOP VIEW
4"
Rear of unit
1"
1"
Side
Side
Front of unit
SIDE VIEW
1"
Top of unit
5
Publicité
Chapitres
Table des Matières
Dépannage
