Grill & Fan Blade Assembly - Varma FT30-16J Mode D'emploi

Part figure
1. Front grill
2. Circlip
3. Grill clip
4. Blade
5. Plastic nut
6. Rear grill
7. Motor shaft
8. Oscillating clutch knob
9. Pedestal
10. Spinner
11. Base
12. Piano switch
13. Tight
14. Loose
Grill & fan blade assembly
1. Fix the base.
2. Fix the rear grill to the motor then tighten the plastic nut.
3. .Insert the spinner.
4. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into
groove of the blade.
5. Turn the spinner counter clockwise to tighten the blade.
6. Fix the front grill and the rear grill with circlip clip and then use the fasten clip to
tighten the fan grill.
Notice VENTILATEUR À POSER Ø30CM 30W – Ø12'' 30W DESK FAN
BRICODEAL SOLUTIONS – 4 rue Yves GLOTIN – CS40005 33083 BORDEAUX CEDEX - FRANCE