Configuring - Zeller Oxi 3300i Mode D'emploi

Configuring

Baud
4 0 8
p
9 4
O
n T 3
1
Time
d 1
A r n
Y E
9
0 0
Day.Month
10
Configuring
Note
You can leave the configuration menu at any time with <M>. The parameters
already changed are stored.
Procedure for configuring (factory settings appear in bold typeface):
Switch off the measuring instrument.
While pressing the <M> key, press <
Select the required Baud rate with <L> <M>.
0
Selection: 1200, 2400, 4800, 9600 Baud.
Then press the <RUN/ENTER> key.
The air pressure is only displayed if an oxygen sensor is connected. Oth-
erwise, "---" appears.
mbar
Continue with the <RUN/ENTER> key.
9
Select the required calibration interval for oxygen measurements with
<L> <M>.
Selection: 1... 14... 999 d.
Then press the <RUN/ENTER> key.
4
Switch the automatic measuring range selection AutoRange on/off with
<L> <M>.
Selection: YES (On), no (Off).
S
Then press the <RUN/ENTER> key.
ARng
Select the date and time step-by-step with <L> <M>. In between, press
4
the <RUN/ENTER> key each time.
When the last <RUN/ENTER> key has been pressed, the instrument
changes to the last active measuring mode.
Oxi 3300i/3400i
>.