Table des Matières
Publicité
HIKOB WISECOW
Version 2018V2
interference will not occur in an installation. If this equipment does cause harmful
interference to radio or television reception which can be determined by turning the
equipment off and on, the user is encouraged to try to correct interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
RF exposure: This device complies with FCC RF radiation exposure limits set forth for
general population. This device must be installed to provide a separation distance of at
least 20cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.
d. Canada
Transmitter Antenna: Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.
Licence-Exempt Radio Appartus: This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
RF Exposure: This device complies with Industry Canada RF radiation exposure limits
set forth for general population. This device must be installed to provide a separation
distance of at least 20cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
Avis de conformité à la règlementation d'Industrie Canada Conformément à la
réglementation d'lndustrie Canada, le présent émetteur radio peut fonctionner avec une
antenne d'un type d'un gain maximal (ou inférieur) approuvé pour l'émetteur par lndustrie
Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des
autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante.
Le présent appareil est conforme aux CNR d'lndustrie Canada applicable aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
2018 · Page 5/14
Publicité
Table des Matières
