Defrosting The Cooler; Adjust Temperature - WMF Coller 9192 Mode D'emploi

5.3

Defrosting the cooler

If the ice layer is more than 3 mm thick, defrost the
cooler. For coolers with integrated low-level messages,
any ice build-up on the rear vertical wall should be
avoided.
This helps to avoid malfunctions and saves energy.
™ Switch off the cooler using the On / Off switch
™ Disconnect mains plug
™ Leave the front door open
™ Wipe away the water from melting ice with a soft cloth
Never remove the ice layer with sharp or pointed objects.
The surface of the interior of the cooler could be
damaged.
Do not use heating appliances (hair dryer, heat gun,
steam cleaners, etc.) to defrost.
™ Close the front door before switching on again
5.4

Adjust temperature

™ Remove the cap on the back of the cooler
turn clockwise
turn counter clockwise g warmer *
A quarter turn is approx. 2K.
* The stop for the warmest setting has a slight detent. Turning past the
detent will switch off the cooler.
Series 9192
User Manual WMF Cooler
g colder
Series 9469
Care
Follow the manual.
Observe the Safety chapter.
Series 9468
47