Bayco Products NightStick NSR-1514 Mode D'emploi

Instruction Manual
NSR-1514
THANK YOU FOR PURCHASING THE NSR-1514 LED WORK LIGHT.
SAVE THESE INSTRUCTIONS.
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR WORK LIGHT.
Please read these instructions before using your NSR-1514. They include important
safety and operation information. Be sure to charge the 1514 fully before the first use.
WARNINGS
y Lithium-ion batteries must be used and charged properly. Improper use can result in
serious injury, fire, or death.
y NOT FOR USE IN HAZARDOUS LOCATIONS. Do not use this product in explosive
atmospheres, near flammable liquids, or where explosion proof or intrinsically safe
lighting is required.
y DO NOT use this product in the proximity of vehicles or equipment when there is a
risk of flammable liquids coming into contact with the flashlight.
y Light can become hot while on. To prevent damage DO NOT cover or place next to
any potentially flammable materials while in use.
y Do not leave the battery in direct sunlight or use or store the battery inside cars in
hot weather.
y Do not expose the battery to water or salt water, or allow the battery to get wet.
y Do not store the battery with metallic objects that may cause a short circuit.
y Immediately discontinue use of the battery if the battery emits an unusual smell,
feels hot, changes color, changes shape or appears abnormal in any way.
y Keep out of the reach of children.
INITIAL USE
y Fully charge the NSR-1514 before the first use, or if the battery is new or has been
unused for several months. The maximum charge time required is approximately 3
hours.
DAILY USE
y Use only the supplied Nightstick AC, DC adapter, or USB cord. For best performance,
charge the NSR-1514 when the light starts to dim.
y Connect the AC, DC adapter, or USB cord into the bottom of the light.
y The total time to full charge the NSR-1514 varies depending on the remaining
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
charge in the battery pack.
y In order for the light to be waterproof the rubber plug must be reinserted into the
charging port.
OPERATION
CAUTION: BECAUSE THE NSR-1514 HAS A MAGNETIC BASE, IT IS LIKELY
THAT IT WILL BE PLACED IN AN ELEVATED POSITION ABOVE THE GROUND.
THEREFORE CAUTION SHOULD BE USED TO BE CERTAIN THAT THE MAGNET
IS SECURELY ATTACHED TO THE METAL SURFACE BEFORE RELEASING THE
LIGHT. IT IS ALSO ADVISED THAT EXTRA CARE BE TAKEN WHEN ADJUSTING
OR MOVING THE CORD SO THAT THE WORK LIGHT DOES NOT COME LOOSE
AND FALL TO THE GROUND.
The NSR-1514 has a single sealed push button switch located on the back of the
light head.
Turning the light on high mode:
y Press and release the button one time.
Turning the light on low mode:
y Press and release the button a second time.
Turning the light off:
y Press and release the button a third time.
WARRANTY
1 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and
materials to the original purchaser for 1 year from the date of purchase, and includes the
LEDs, housing, lenses, electronics, switches, rechargeable batteries and chargers. Bulbs
(other than LEDs) are covered for 90 days from the date of purchase.
We will repair or replace this product should we determine it to be defective. This is the
only warranty, expressed or implied, including any warranty of merchantability or fitness for
a particular purpose.
For a complete copy of the warranty, go to www.nightstick.com/nightstick-product-
support/warranties. Retain your receipt for proof of purchase.
RECORD YOUR WARRANTY INFORMATION
Please record your NSR-1514 product information here for use with any warranty
claim.
Serial Number _____________________________
Date of Purchase ______________________________
MODE D'EMPLOI
MERCI D'AVOIR ACHETÉ LA LAMPE DE TRAVAIL DEL NSR-1514.
VEUILLEZ CONSERVER CES DIRECTIVES
VEUILLEZ LIRE CES DIRECTIVES AVANT D'UTILISER VOTRE LAMPE DE
AVERTISSEMENTS
y Les batteries au lithium-ion doivent être utilisées et rechargées correctement. Une
mauvaise utilisation peut causer des blessures graves, un incendie ou la mort.
y NE PAS UTILISER DANS DES ENDROITS DANGEREUX. Ne pas utiliser ce produit
dans des atmosphères explosibles, à proximité de liquides inflammables, ou un
INS-NSR-1514-17
NSR-1514
TRAVAIL.