Hardware Installation - Ebode IPV38 Guide De Démarrage Rapide

1. Introduction
Thank you for purchasing the ebode IPV38. With this product you can access your camera's
live video feed from your web browser or through software on your computer, your tablet,
or your smart phone.
Once you have your camera configured, you may access your camera by either of these
methods:
1. Use the IPcam setup program on the included CD and click on your camera.
2. Once you are viewing your camera's live video, you can save the web address as a
favourite. Then you can use that saved favourite without using the IPcam setup program
each time.
3. In your web browser, type the IP address of your camera as a new web address.
4. To use a friendly name like 'mylivingroom.dyndyns.org', see the owner's manual for how
to configure your camera to use Dynamic DNS.
5. To see your camera over the Internet, or from a cell phone through a 3G/4G connection,
use software, or see your owner's manual to configure your router for Port Forwarding.
2. Set Contents
● IP Camera
● Quick Start Guide
● CD
● Mounting bracket
3. Setting up the device

3.1 Hardware Installation

You need to set up your camera using a network cable (wired) first, before you can use it
wirelessly, so let's start with plugging in the network cable. Plug one end of the network
cable into the camera, and the other end into an empty port of your router/switch/modem.
Install the Wi-Fi antenna. Plug the power adaptor into the camera and into an AC outlet.
Please note that your power supply will fit both the AC outlet and the Audio Output, please
make sure you put it in the AC outlet, or your IP camera will not be powered.
7-11-2013
● Wi-Fi Antenna
● Power Supply
● Network Cable
3 IPV38 / IPV38WE