Hayward SharkVAC XL Pilot Guide De L'utilisateur page 25

Take a moment to get familiar with the cleaner using the figure 3. Throughout this manual reference to
this figure is made when referring to different components of the cleaner.
Remove the cleaner by placing the carton down and removing
it from the box as shown. The cleaner and the Power Supply is
premounted to the cart. See the figure 4 for Caddy Cart.
1. Select the nearest 230 V
protection device to protect people from electric shock caused by a possible break in the electrical
.
insulation
2. Place the power supply so that it is at a minimum distance of 3.5 meters from the pool edge. The
length of the standard cable is 16,76 meters.
3. Connect the floating cable to the power supply. Use only the original Power Supply manufactured by
Hayward.
4. Place the cleaner in the pool. It will slowly sink to the bottom of the pool as the air inside is released.
5. Connect the power supply to the protected outlet and switch it on. The cleaner will perform a self-
diagnostics routine for several minutes before starting the cleaning cycle.
⚠ Caution: DO NOT switch power supply "ON" when the cleaner is out of water. This may result in
damage to the pump and drive motor seals, which will VOID the warranty.
6. The cleaner will automatically shut off after 90 minutes for the quick clean cycle or 4 hours for a full
cleaning cycle. If your pool is cleaned in less time than 90 minutes, you may shut the cleaner off
manually by switching the power supply to the off position.
Should a second cleaning cycle be required, switch OFF the power supply for 10 seconds and
restart. (see Power Supply operating instructions)
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Page 5 of 19
GENERAL OPERATING INSTRUCTION
 outlet that is close and protected from short-circuits. Fit a 30 mA differential
Use of non genuine Hayward manufactured parts will void all warranty.
SharkVAC XL™ Pilot / e.VAC PRO²™ Robotic cleaner
Fig. 2
3.5 m
Fig. 1
Rev. B