Technical Specifications - König Electronic HC-EB10 Mode D'emploi

CLEANING & MAINTAINANCE
When the blanket is not in use please disconnect it from the mains outlet. Always unplug the blanket before
cleaning.DO NOT submerge the controller in water or get it wet at all.
CLEANING
Do NOT dry clean this blanket as it could damage the heating elements.
To clean the blanket, wipe it down with a soft damp cloth with very mild detergent. Allow it to dry naturally
and thoroughly before using or storing it. Do not use industrial solvents such as benzene, kerosene or similar
solvents to clean it. Do NOT wring out the blanket.
Do NOT dry using a tumble dryer. Do NOT iron the blanket. Do NOT use an appliance such as a hair dryer
to dry it. Allow the blanket to dry naturally. Do NOT use the blanket if it is damp or wet Have it dried out
thoroughly!
MAINTAINANCE
Do NOT try to repair the blanket if faulty – have it looked at by a qualified person. The blanket does not
contain any serviceable parts. Examine the blanket frequently to check that there are no signs of wear or
damage. If any damage/wear is spotted, do not use the blanket and seek specialist advice. If the mains lead
or controller is damaged, do not open or attempt to repair as it must be serviced by a qualified person.
STORAGE
When not in use, gently fold the blanket and place back into the PVC bag it arrived in.
MAINS SUPPLY
This electric under blanket must be connected to a suitable 230 V (50 Hz) mains supply.
Fully unwind the mains lead before use. Always unplug from the mains supply when not in use.

TECHNICAL SPECIFICATIONS

Model no: HC-EB10 - 1 x 60W – 1A – AC 250V - Controller type: 1 x KDA6-FT
Safety precautions:
To reduce risk of electric shock, this product should ONLY be opened by an
CAUTION
authorized technician when service is required. Disconnect the product from
RISK OF ELECTRIC SHOCK
mains and other equipment if a problem should occur. Do not expose the product
DO NOT OPEN
to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders and
are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for these
products.
4