Yalp Solar YA 3200 Instructions D'installation page 37

the tube in the hole. Pull the red and black cable
through the tube and cut the cable with excess.
B.3 Align the anchor plate above the middle of the
hole, using the wooden packaging beams.
B.4 Screw the anchors in place.
C. SURFACE MOUNT
NOTICE Make sure the necessary preparations
have been made according to chapter A.
C.1 Use the concrete cutter to cut a slot according
to the indicated dimensions. Align the anchor plate
according to the image.
NOTICE The slot can be made in various
directions. Please make sure the cable slot will not
cross any of the anchor points, according to image
A.7.
C.2 Determine the length of the cable protection
tube (conduit) and cut to size with a knife. Place
D. INSTALLATION
WARNING Installation should be done by a
certified installer according to local regulations on
electrical safety (e.g. NEN 1010).
CAUTION For assembling and installing the
product it is recommended to work with two
persons
CAUTION The people installing the product
should wear the required protection and clothing
D.1 Fasten the anchor plate at the two middle
anchors only.
D.2 Place the Solar pole on the hinge of the anchor
plate.
D.3 Secure the Solar pole on the hinge by fastening
the locking plate.
D.4 Let the Solar pole rest on something, for
example the transport crate.
D.5 Place the Y-shape on top of the Solar pole
according to the indicated orientation and fasten
the Y-shape from all four directions.
D.6 Place the Solar panel profiles on top of the
Y-shape (according to the image) and fasten them.
D.7 Run the cables through the Y-shape and the
Solar pole.
B.5 Pour the concrete to the indicated height and
wait until it has hardened.
B.6 Fill the remaining cavity with sand to reach
ground level.
NOTICE You can now continue the installation by
following the steps in chapter D.
the tube in the slot. Pull the red and black cable
through the tube and cut the cable with excess.
C.3 Pour the concrete to the indicated height and
wait until it has hardened.
C.4 Align the anchor plate as shown in the image.
C.5 Drill 6 holes using a rotary hammer according
to the instructions of the used chemical anchor
(not included).
C.6 Insert the chemical anchors according to their
instructions.
D.8 Connect the Solar panel to the cables in the
Solar pole. A "click" sound will indicate a successful
connection.
NOTICE Make sure to connect the positive and
negative poles correctly.
D.9 Run the cables entirely though the Y-shape and
fasten the Solar panel on the profiles.
D.10 Carefully lift the Solar pole to an upright
position with three persons.
WARNING Lifting hazard! Single person lift could
cause injury. Work with two people when lifting the
Solar pole.
WARNING Possible injury! A falling pole could
cause injury or damage. Make sure the pole does
not fall when lifting it.
D.11 A "click" sound indicates that the Solar pole is
correctly positioned. The security hinge prevents
the Solar pole from falling back again.
WARNING Mind your hands! Risk of trapping
hand/finger. Make sure no hands are near the
bottom of the Solar pole when moving it to an
upright position.
37
EN EN
NL
DE
FR
YA3200-210723