Cleaning, Care & Maintenance - Buffalo DB175 Mode D'emploi

Pass-through Operation
To set-up the toaster for pass-through operation:
1. Remove the back door of the appliance.
2. Fix it inside the appliance by resting the curved
lip of the door on the two pins at the end of the
belt [Fig. 2].
3. Attach the Pass-through chute to the hanging
screws at the rear of the appliance.
Toasting
The BUFFALO Conveyor Toaster has 3 power levels:
Top&Bottom Full power to both upper and lower elements
Top Full power to upper element only
Standby Energy Saver (reduces power to minimum, providing quick heat up times
when required)
The speed of the conveyor belt can also be altered to adjust the cooking level.
• Turn the knob clockwise towards Light (increases the speed of the belt) for a lighter toasting.
• Turn the knob anti-clockwise towards Dark (slows the speed of the belt) for a darker toasting.
To toast:
1. Connect the appliance to the power supply.
2. Set the power and belt speed.
Note: BUFFALO recommend that the Conveyor Toaster is allowed to heat up for
30 minutes before use.
3. Place the bread on the Feeder.
4. The bread is toasted as it travels through the appliance.
5. If necessary, adjust the power level / belt speed to achieve the desired level of toasting.
Cleaning, Care & Maintenance
• Always turn Off the appliance and disconnect from the power supply before cleaning.
• Allow the appliance to cool before cleaning.
• Regularly remove and empty the crumb tray.
• Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.
DB175_ML_A5_v3 20201126.indb 5 DB175_ML_A5_v3 20201126.indb 5
UK
Pins
Back door
Hanging screws
Fig. 2
5
2020/11/26 09:55 2020/11/26 09:55