GE IM-5SS Manuel D'utilisation Et D'installation page 12

ICEMAKER INSTALLATION INSTRUCTIONS K
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1 PREPARE FOR INSTALLATION
• Remove the upper outlet cover with a flat-blade
screwdriver.
• If there is already an icemaker bracket (24) installed in
the freezer, remove the two screws holding on the cover.
Remove and discard the cover. Go to Step 5.
REMOVE FILL HOLE PLUG
2
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
Installation Instructions
Unplug the
Pliers Sharp knife
Cover
Remove
plug
or K
C
3 INSTALL FILL TUBE
• Slide the insulated fill tube (15)
onto the water tube inlet (14),
making sure that the open side
of the fill tube faces up.
• Go to the back of the
refrigerator. On the tube side
of the water tube inlet (14) there is an adhesive
backing. Remove the adhesive backing and slide
the tube into the hole near the top at the back of
the refrigerator. Firmly press on the inlet to secure
it to the refrigerator.
4 INSTALL MOUNTING BRACKET
• Remove the three small plug buttons on the rear
wall of the freezer and replace them with three
screws (25) supplied with the icemaker kit. Do
not screw them all the way in. The screws should
extend approximately 1/4" (6 mm) out from
the freezer wall.
• Install the icemaker
bracket (24) by hanging
it from the three screws
that were just installed.
Tighten the three screws
securely.
5
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
12
15
14
Hole for
wire tie