Technical Specifications - Velleman CAMCOLD17 Notice D'emploi

6. Installation
• Choose the location for the dome camera, keeping following guidelines in mind:
o Do not install the camera in locations where extremely high or low temperatures, high humidity,
water vapour or steam, dust or excessive vibrations may occur.
o Avoid mounting the camera near high electro-magnetic fields as this will influence image quality.
o Do not aim the camera at the sun or other extremely bright objects or reflections.
• Fix the mounting plate (4) to the wall with 4 anchors (when applicable) and 4 screws. Note that
mounting will be easier when the transparent cover and plastic protective cap are removed [1&2].
• Connect the video connector [B] to a monitor (not incl.) or a sequential switcher/quad splitter (not incl.)
when connecting multiple domes.
• When using an RS485 controller (not incl.) and/or DVR (not incl.), connect the white wire [A] of the
camera to the '+' and the green wire [A] to the '-' of the RS485 controller and/or DVR.
• Connect the power connector [C] to the included 12VDC power adaptor. Plug the other end of the
adaptor in the mains.
Note: only use the included power supply.
• Manually adjust the focus by rotating the lens [3]. Secure the position by rotating the ridged ring towards
the housing.
• Re-install the plastic cover. Make sure the tabs snap into place [2].
• Place the transparent cover back and screw it clockwise. Make sure it is closed firmly.

7. Technical specifications

camera
system
sensor
number of pixels
horizontal resolution
video S/N ratio
min. illumination
IP rating
pan/tilt
pan angle 0° -200°
pan speed 12°/s
tilt angle 0° - 90°
tilt speed 12°/s
preset points 12 (10 normal, 2 auto scan)
general
operating temperature
power supply
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.velleman.eu. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without
the prior written consent of the copyright holder.
15/05/2009
PAL
1/3" Sony colour CCD
582 (H) x 500 (V)
420 TV lines
>= 48dB
0.2 lux / F1.2
IP65
0 ~ 55°C
12VDC/1A (not incl.)
CAMCOLD17
iris
focal length
back light compensation
video output level
synchronizing system
gain control
white balance
electronic shutter control auto
communication
protocol
baud rate
housing
ID number 1~9
ID number 1~64
dimensions
weight
5
auto
6mm
auto
1.0Vpp / 75Ω, composite
internal
auto
auto
RS-485
Pelco-P or Pelco-D
2400, 4800 bit/s
aluminium
controllable via IR remote
controllable via Pelco controller
180 x 140 x 140mm
1150g
©2008 Velleman Components nv
®