Approved Power Unit; Intended Use; Ec Declaration Of Conformity - Dolmar MB-CS Instructions D'emploi

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Dimensions: length x width x height (with brushes)
Net weight
Brush width
Outer diameter of the brush
Model:
Dimensions: length x width x height (with sweep drums)
Net weight
Sweep drum width
Outer diameter of the sweep drum
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.

Approved power unit

This attachment is approved to use only with the follow-
ing power unit(s):
• CS-246.4C Multi Function Power Head
• AC3611 Cordless Multi Function Power Head
WARNING:
Never use the attachment with
non-approved power unit. Non-approved combi-
nation may cause serious injury.
Symbols
The following symbols are used on the attachment and
this instruction manual. Understand these definitions.
Take Particular care and attention!
Read instruction manual.
Wear protective helmet, eye and ear
protection!
Wear sturdy boots with nonslip soles.
Steeltoed safety boots are recommended!
Keep bystanders at least 5 m (17 ft) away.
The brushes or sweep drums rotate in the
direction of the arrow.
When attaching the brushes or sweep
drums, make sure that the gear case is
facing upward.
1,145 mm x 600 mm x 362 mm
1,159 mm x 600 mm x 362 mm

Intended use

MB-CS
This attachment is designed for only the purpose of
sweeping ground and paths in conjunction with an
approved power unit. Never use the attachment for other
purposes. Abusing the attachment may cause serious
injury. This attachment is intended for commercial use.
MW-CS
This attachment is designed for only the purpose of
clearing wet materials, such as leaves, dirt, and removing
water from solid surfaces in conjunction with an approved
power unit. Never use the attachment for other purposes.
Abusing the attachment may cause serious injury. This
attachment is intended for commercial use.

EC Declaration of Conformity

For European countries only
We as the manufacturers: Makita Europe N.V.,
Business address: Jan-Baptist Vinkstraat 2 3070
Kortenberg BELGIUM. Authorize Yasushi Fukaya
for the compilation of the technical file and declare
under our sole responsibility that the product(s);
Designation: Power Brush Attachment / Power
Sweep Attachment. Designation of Type(s): BR400MP,
MB-CS / SW400MP, MW-CS.
Fulfills all the relevant provisions of 2006/42/EC and
also fulfills all the relevant provisions of the following
EC/EU Directives: and are manufactured in accor-
dance with the following Harmonised Standards:
EN 60335-1:2012+A11:2014+A12:2017, EN
60335-2-72:2012.
Place and date of declaration: Kortenberg, Belgium.
26.01.2018
Responsible person: Yasushi Fukaya, Director -
Makita Europe N.V.
2 ENGLISH
MB-CS
6.3 kg
600 mm
250 mm
MW-CS
7.2 kg
590 mm
265 mm