Setting Up The Unit - BoomToneDJ Hazer 2000 Mode D'emploi

Setting up the unit

To make sure that you use this machine as intended, BoomToneDJ recommends to follow
the steps described below.
Liquid Before turning on the machine, make sure there is enough fog liquid in the tank.
We recommends to use our fog liquid or efficient/economical and creates almost
odorless fog. Approximately ¾ of its capacity. Overfilling the tank may cause the liquid to
spill during transport, because of shocks, impact and tilting of the machine. Fluid
consumption depends on the type of fluid, the amount of fog that you wish to create and
the timespan of use.
Wired timer remote
Wired timer remote
Connect this controller with the 5-pin DIN connector on the rear of the machine.
1. Interval selection: Determines the timespan when the machine is activated.
2. Duration selection: Determines the duration if the timer activates the machine. 3.
Output intensity: Output 0-100% (variable)
4. Timer functionality on/off
5. Continuous fog: Continuous operation with the selected output intensity
9