Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY AND SET-UP :
Installation of the platter :
Place the belt on the platter
-
-
Set the platter ( + the belt ) on the axe.
-
Turn the platter until you see the motor.
Place the belt on the motor
-
Installation of cartridge :
To install the cartridge, you can read the cartridge's owner
manual. Connect the lead wire to the cartridge terminals.
The terminals of most cartridges are color-coded.
Connect each lead wire to the terminal of the same color.
White (L+) : left channel +
Blue (L-) : left channel -
Red (R+) : right channel +
Green (R-) : right channel -
Installation of headshell :
-
Insert the headshell into the front end of the tubular
tone arm.
-
Turn the locking nut counter-clockwise while the
headshell is firmly held horizontally.
Installation of counter weight :
Slide counter weight onto the rear of the tone arm
Twist the counter weight counter-clockwise and it will screw
onto the rear of the tone arm.
Adjustement of horizontal zero (0) balance and stylus
pressure :
-
If
your
cartridge
protection, remove it and be careful not to touch
the stylus tip.
-
Release the arm clamp and lift the tone arm from
the arm rest.
-
Turn
counterweight
clockwise
until
horizontally as floating freely. During adjusting the
horizontal zero (0) balance, be careful that the
stylus tip does not contact the turntable mat or
turntable base.
-
After the tone arm is horizontally zero (0)
balanced temporily, place the tone arm on the
arm rest and lock it with the arm clamp.
-
While rotating the stylus-pressure ring, hold the
counterweight steady with one hand until "0" on
the ring aligns with center line on the tone arm
rear shaft. Now the adjustement of the horizontal
zero (0) balance should be completed.
-
After adjusting the horizontal zero (0), turn the
balanced counterweight counter-clockwise to get
the proper stylus pressure as the cartridge
manufacturer's recommandation when it meets
center line on the tone arm rear shaft.
has
a
detachable
stylus
clockwise
or
counter-
the
tone
arm
is
balanced
anti-skating adjustement :
Set the anti-skating control knob to the same value as the
stylus pressure
Pitch adjustement
The pitch can vary +/- 10% when the pitch control
-
is moved away from center.
-
When the platter is spinning, the strobe light
illuminates the strobe RPM indicator on platter
WARRANTY CONDITIONS
BST equipment is covered by a 1-year warranty on parts and
labour except for Crossfaders (90 days).
The following rules apply from the day the equipment leaves the
factory:
The date on the invoice is considered to be the date the warranty
begins.
Only companies approved by BST are allowed to work on the
equipment. Warranty becomes void when other service
technicians open the equipment.
During warranty period, defective equipment must be sent by pre-
paid mail in the original box.
BST will return the goods by pre-paid mail during the first year of
warranty; thereafter the mailing cost is to be paid by the recipient
Potentiometers have a limited lifetime and are not covered by the
manufacturer for more than normal use.
For all service enquiries, refer to your local distributor, as he is
best able to help you.
SPECIFICATIONS :
Belt drive manual turntable
Speed : 33, 45 RPM
Général :
Power supply :
Power consumption :
Dimensions :
Poids :
Checklist of parts :
-
platter (x1)
-
mat (x1)
45 RPM adapter (x1)
-
Counterweight (x1)
-
-
Headshell (x1)
Belt (x1)
-
4
AC 115/230V~50/60Hz
8W
450x250x350mm
4.25Kg
Publicité
