Design Of The Device - Bresser 49-14911 Mode D'emploi

Design of the device

A: Retaining plate with spring clamp (A1) and retaining
bracket (A2) to fix your Smartphone
B: Eyepiece clamp with universal size adjustment
C: Stepless adjustment of the eyepiece clamp
Operation
Please make sure that the clamps are able to fasten well
during the installation so that there is no risk of your phone
falling. Erect the spring clamp and retaining brackets (A1 and
A2), so that they are in an upright position. Pull the bracket
fitting, which is marked with a small arrow, outward in the
direction of the arrow and retain it in its position. Now insert
your Smartphone with the camera in the direction of the
eyepiece clamp. Slowly let go of the spring clamp once again.
This locks the phone independently. Please ensure proper
fitting within the clamping device. The contact pressure may
have to be manually raised a little bit in order to correctly
secure the phone.
Configure the opening of the eyepiece clamp (B) using
the adjustment wheel (C), so that the adapter can move
effortlessly over the eyepiece of the optic employed. Slide
it so far over, until your phone's camera is placed just over
the eyepiece lens. Now fix the adapter by means of the small
rotational wheel (C) until the rim of the eyepiece clamp (B) is
firmly clamped on the eyepiece, well hand-tightened. Please
also ensure the proper secure fitting of the eyepiece and the
adapter on the eyepiece here. The complete set should now
be connected to the optic employed, free of play.
Once again carefully release the spring clamp (A1), in order to
place the phone with the camera centrally over the lens of the
DE
GB
FR
NL
IT
ES
9