EHEIM play 2500 Notice D'utilisation page 18

English
‧ The appliance has a magnet with a strong magnetic field that can affect
pacemakers or implanted defibrillators (ICD). Maintain a distance of at
least 30 cm between the implant and magnet.
4. Commissioning
Installing the water feature nozzle
1. Screw the water distributor ③ onto the pump (⌦B).
2. Screw the telescopic pipe ② onto the water distributor.
3. Push the required water feature nozzle (⌦A) onto the telescopic pipe.
Connecting the hose
1. Use a saw to shorten the outlet spigot to the diameter of your hose (⌦C).
2. Screw the outlet spigot onto the water distributor (⌦D).
3. Connect your hose to the outlet spigot.
‧ The hose connection is only required if the pump should additionally supply a filter or stream.
‧ We recommend fastening the hose with a hose clamp
5. Operation
CAUTION! Material damage.
The pump must not run dry.
Switching on the pump
1. Place the pump on a solid surface as horizontal as possible in the pond so that the filter housing is
covered by at least 20 cm of water. Pay attention to the maximum pond depth (see Technical data).
2. Pull the telescopic pipe ① out to the required length (⌦J).
3. Align the telescopic pipe vertically with the ball joint ③.
4. BUBBLE water feature nozzle: Pull the insert ② out of the nozzle until the water feature has the
required shape.
5. Insert the mains plug in the mains socket. Attention: The pump starts immediately!
Adjusting the water distribution
1. Regulate the amount of water for the water feature(⌦F) with rotary tap 1 ①.
2. Regulate the amount of water for the hose connection with rotary tap 2 ②.
Switching off the pump
1. Remove the mains plug from the mains socket.
18