Control Center - JOYTECH Control Center 540C Guide De L'utilisateur

Connecting to a network
The Control Center™ 540C has an integral 5 port
10/100Mbps Ethernet Hub. The Hub is used for connecting
to Xbox Live®, home networks and any other network
enabled devices.
NOTE: You must have a high-speed (cable or DSL) internet
connection to play on Xbox Live®.
1) Connect the Ethernet Cable (supplied) to the Ethernet
LAN port on the rear of your Xbox 360™ console and the
other end of the Ethernet Cable to the port labeled IN1 on
the Control Center™ 540C Hub.
2) Connect an Ethernet Cable to the UPLINK port on the
Control Center™ 540C Hub and the other end of the
Ethernet Cable to your high-speed modem.
XBOX360 Console
Remote Control
You can page through each Input Channel by pressing
the Input Select Button on the front panel of the Control
Center™ 540C. Alternatively you can select each Input
Channel by using the directional or numerical buttons on
the Remote Control.
The Standby Button located on the Remote Control
allows the Control Center™ 540C to be switched from
on to standby mode.
NOTE: You can connect other devices to the
Ethernet Hub on LAN ports 2 - 5
The table below shows the status of the LAN port
LED's during use.
LED status
(Red) On
(Yellow) Flashing
540C Control Center
Description
Good connection
Receive data
Network Cable
(supplied)
Cable / DSL Modem
(not supplied)
Standby
Directional
Numerical
Buttons
ENGLISH 7