Cleaning And Maintenance - KINZO 31L801 Mode D'emploi

Slide the choke (2) all the way to the left.
I
Put the on/off switch (1) in the position
I
"ON".
Pull gently on the start cord (3) until you
I
feel resistance.
Pull the start cord forcefully. Repeat this
I
until the motor is running.
Slide the choke slowly all the way back to
I
the right.
Use of the generator
Start the motor as described above.
I
To connect an electrical machine or
I
equipment, put the mains plug in the
alternating current output (6).
In case of short circuit or overload of an
output an electronic safety feature switches
this off.
To switch the alternating current output
I
back on, press the reset button (7).
Switching off (fig. A & B)
Be sure that NO load is connected.
I
Put the on/off switch (1) in the position
I
"OFF".
Turn the fuel cock (4) to the position "OFF".
I

CLEANING AND MAINTENANCE

For good functioning and a long lifespan for
the machine, regular cleaning and
maintenance is essential.
Do not smoke during the below
work. Do no work in the vicinity
of sparks, flames or open fire.
Air filter (fig. C)
The air filter should be cleaned after every
50 operating hours.
Loosen the 2 screws (8).
I
Remove the lid (9).
I
Remove the air filter (10) from the lid.
I
Clean the filter with spirits or ethanol.
I
Sprinkle the filter with petrol.
I
Pinch the filter out. Do not twist!
I
28
Fuel filter (fig. D)
Remove the lid (5) from the filler opening.
I
Lift the fuel filter (11) from the filler opening.
I
Clean the filter with spirits or ethanol.
I
Dry the filter with a soft cloth.
I
Replace the filter in the filler opening.
I
Place the lid back on the filler opening.
I
Spark plug (fig. E & F)
Remove the spark plug cable (12) from
I
the spark plug (13).
Remove the spark plug using the spark
I
plug spanner.
Clean the electrode (14) using a steel brush.
I
Check the contact distance (correct value
I
0.7 - 0.8 mm) and adjust as necessary.
Replace the spark plug.
I
TROUBLE-SHOOTING
If the machine does not work correctly,
follow the directions below to solve the
problem. If you can't solve the problem
yourself, contact your dealer.
Engine does not start
Check if the fuel cock and the on/off
I
switch are in the ON position.
Check if there is fuel in the tank.
I
Pull harder on the start cord.
I
Check if the spark plug is properly placed.
I
Check if the spark plug cable is on the
spark plug. Clean the spark plug and
check the contact distance.
Motor runs irregularly
Check if the spark plug is properly placed.
I
Check if the spark plug cable is on the
spark plug. Clean the spark plug and
check the contact distance.
Check if the right fuel mix has been used.
I
Generator supplies no energy
If the indicator lamp is not on, there is a
I
defect that you cannot correct yourself.
31L801