Bimar J8882H Notice D'instruction page 13

USE
The citrus squeezer consists of the following control devices:
- pressure switch which activates the motor as soon as the squeezing cone is
depressed; the motor stops when the pressure is released
- right-left rotation alternating each time the squeezing cone is depressed
, and is complete with:
- Motor unit (1) with liquid drainage holes and base with anti-scratch feet and
cone rotation pine
- Jug (2) with capacity 1.0l, graduated scale and handle: it must be inserted
correctly, so that the two arrows (▲ and ▼) on the two parts are aligned
- two concentric strainers, one above the other (3): they fit into the top of the
jug; the position of the top one can be adjusted by moving the button (4) to
the right or left; they filter all citrus flesh.
- 2 cones: large (5) and small (6), for citrus of al sizes; the small cone engages
with the drive shaft and has clips for securing the strainer; the large one fits
on top of the small one, pressed into place
- Lid (7) which fits snugly onto the strainer and jug
First use
Wash and dry all parts in contact with foods (jug, strainer, cones, lid), following
the instructions in the cleaning and maintenance section
Use
 Fit the jug correctly onto the motor unit.
 Fit the strainers onto the jug.
 Fit the smaller cone onto the drive shaft and also fit the larger cone if required.
 Connect the plug to the power socket.
 Cut the fruit for squeezing in half, place the part for squeezing, properly
aligned, on the cone and press gently: the motor runs automatically and
squeezes the juice, which collects in the jug.
 To stop the motor, release the pressure on the fruit. To switch off the motor
completely, remove the plug from the power socket,
 The filter will trap the seeds and flesh.
 Do not squeeze the fruit too hard as this will over-strain the motor.
 Only use the citrus squeezer if all its components are correctly fitted, and
always alternate 15 seconds of operation with a 15 second pause, for a
maximum of 10 cycles.
room temperature.
 Never exceed the juice level marked on the jug (1.0 litre), as it may overflow.
 After use, remove the plug from the power socket,
 To pour the juice into the glass, remove the cones and release the jug from the
motor unit.
Remove the plug from the power socket if unused for even short periods of time.
After which leave it off and cool down to
13