Adjusting The Volume - Ryobi P3520 Manuel D'utilisation

 Press the power button to turn the product on.
 When the product is turned on, it will begin searching for
a device with which to pair.
NOTE: The speaker will attempt to connect with a device
for 5 minutes before it stops searching.
 To connect, using your BLUETOOTH
RYOBI P3520 in your settings for BLUETOOTH
 To disconnect the current device and allow connection to
another BLUETOOTH
the power button for a few seconds. The speaker will
again search for devices with which to pair.

ADJUSTING THE VOLUME

See Figure 4, page 11.
When the product is turned on or when the battery pack is
removed and replaced, the product will return to its maximum
volume setting.
 To increase the volume: press the VOLUME UP button.
 To decrease the volume: press the VOLUME DOWN
button.
NOTE: Volume may also be adjusted by pressing and hold-
ing the VOLUME UP or VOLUME DOWN button. A "beep"
will indicate you have reached the highest or lowest volume
the speaker is capable of producing.
NOTICE:
Do not use the speaker at maximum volume for an
extended period of time. It could cause damage to the
speakers and/or amplifiers in your unit.
OPERATION
capable device, select
®
enabled device, press and hold
®
TIPS FOR USING THE SPEAKER IN THE
POOL
See Figure 5, page 11.
WARNING:
The speaker is NOT a toy and is NOT a life saving device.
.
®
To prevent serious personal injury, property damage, or
damage to the speaker, never throw or play games with
speaker and never jump on or over speaker.
 Make sure each of the four latches is securely fastened.
 Place the product into the pool carefully. Do not toss the
speaker into the pool.
 Do not intentionally submerge the product, as it could
damage the speaker.
 Never attempt to release the latches and remove the
upper dome when the product is in water. Doing so will
cause damage to the product or the battery pack.
 Be aware of the product's location in the water at all times.
7 - English