Technical Data; Product Use - Greencut GWP300X Manuel D'utilisation

TECHNICAL DATA

Engine
Cylinder capacity
Power
Fuel capacity
Type of fuel
Oil Capacity
Oil type
Starter system
Input/output size
Maximum pumping height
Maximum flow rate
Maximum suction depth
Weight
NOTE: GREENCUT reserves the right to modify the technical characteristics without prior notice.

PRODUCT USE

PREPARATION
CONNECTING THE WATER INLET PIPE
Use a suitable hose, gasket and clamp. The water inlet hose should be continuous and not bent. The length of the
tube should not be longer than as required. As if it is near the surface of the water supply, the water pump will
perform at its best efficiency point.
ATTENTION: Before pumping, install the filter firmly on the end part of the water inlet pipe. Any
impurities will be filtered, hence avoiding blockages which damage the impellers.
ATTENTION: Make sure to install the gasket and pipe clamp correctly to avoid water leakage and
loss of pump performance. A loose water inlet tube will reduce the performance of the water pump
and the capacity of self suction.
GWP200X
OHV 4 stroke engines
208cc
7cv / 3.600rpm
4.6L
Unleaded 95
0.6L
10W30, 10W40, 15W30 y 15W40
Recoil Start
3" (50mm)
28m
60.000L/h
7m
28kg
Filter
49
Suction port
EN