Cleaning And Maintenance - EuroLite DMX SUPERSTROBE 2700 Mode D'emploi

Strobe addressing
You have to address every strobe to the respective starting address. Otherwise, the channel assignment will
not be correct. All strobes with the same starting address work synchronically.
The occupation of the Dip-switches is as follows:
Strobe Starting address
Strobe 1 1
Strobe 2 3
OPERATION
Caution: Before connecting the strobe with the mains, the Intensity-control and the Flash Rate-control have
to be set to minimum position.
After you connected the effect to the mains, the DMX SUPERSTROBE 2700 starts running.
On the rear panel ot the DMX SUPERSTROBE 2700 there are two controls to adjust the flash frequency (1-
12 flashes per second) and the dimming level (0-100%).
For manual control, all DIP-switches have to be set to 0.

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The protective shield has to be replaced when it is obviously damaged,
so that its function is impaired, e. g. due to cracks or deep scratches!
Strobe Starting address
Strobe 3 5
Strobe 4 7
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
DO NOT OPEN FOR 5 MINUTES AFTER SWITCHING OFF!
Strobe
Strobe 5
Strobe 6
CAUTION!
17
Starting address
9
11