Dmx Mode - Nicols D CHASE 405 II Guide D'utilisation

follow up the instructions below to operate the unit for your desired
performance.
CHASE MODE
Choose this working mode only when you want the device to act as a 4-
channel chaser. This device has 16 built-in programs. You can select to
run any of these programs specifically, or set the unit to chase in a
random sequence among all 16 built-in programs for a more dramatic
show effect. The chase speed can also be adjusted.
1. Connect your lighting fixture to any of the four power sockets on the
pack.
2. Use the mode button to select chase mode: Chase mode is indicated
in LCD display as "PA" followed by numbers 01-16. "PA" stands for
Program Applied. If an "A" appears in the LCD display, you are in
DMX mode, "A" stands for address.
3. Set you desired chase pattern: Once you have selected the chase
function, use the MENU button to select your desired chase. The
chase pattern is represented in the LCD display by "P" followed by
two numbers. You may select any of the 16 built-in programs to run
at a single time.
4. Set you desired chase speed: At this point you may change the
program chase speed. While in chase mode, tap on the MENU
button until the "SP" followed by two numbers is displayed in the
LCD. Then use the ▲and ▼ buttons to adjust the chase speed. A
value of 99 will give you the fastest chase speed (about one step per
0.1 second). A value of 01 will give you the slowest chase speed
(one step per 30 second).
5. You may now change the light intensity: Use the MENU button to
select "d" on the LCD. Use the ▲ and ▼ buttons to change the light
output intensity. 00 will give the lowest output and 99 will give you full
intensity.

DMX MODE

Use this operating mode only if you plan to use your pack as a DMX
dimmer. This function will allow you to turn on and control the intensity of
non-DMX with the use of a DMX controller. On, Off, and Dimming
functions can be performed through this pack. You may also set your
dimmer pack to function as a 1, 2, or 4 channel DMX dimmer pack,
which means you can combine the output functions.
DMX Operation
Connect a DMX controller to your dimmer pack via the 3-pin XLR
connector.
Connect your lighting fixture to any of the four power sockets on the front
of the pack.
Decide if you are going to use your dimmer pack as 1, 2, or 4 channels.
This function allows you to:
Control the output to all four outlets with one DMX channel.
Group outlet channels one and two and group outlets channels three
and four. The first group will be controlled by one DMX channel and the
second group will be controlled by another DMX channel. This gives the
pack a DMX value of two.
8/4