Risk of burns, the water in the tank can reach 60ºC in summer, initially put the cold tap in position,
adjust the water temperature via the mixer by spraying your hand before placing your body under the
shower.
The water flowing out of the shower is not for drinking.
MOUNTING
1. Choose the sunniest location possible.
2. Wrap a few turns of PTFE tape on the threads and hand tighten the bent tube and the showerhead to the shower
body (insert the seal) . Do not use tools.
3. Fix the plate shower (base) on a concrete floor using bolts and anchors provided (Figure 1)
Maximum system pressure feedwater : 3.5 bars, use a pressure limiter if necessary.
4. Connecting the hose to the water inlet of the shower down by interposing the seal and quick coupling. (Figure 1)
STARTING
1. Turn the faucet handle mixer shower on the side "Hot Water" (red mark) to remove air.
2. Open your water supply to fill the shower. It takes a few minutes to fill
3. When the water begins to flow from the shower, turn the shower tap.
4. In summer, a minimum of 2 hours is necessary to rise correctly the water temperature.
5. To avoid burns, always open the tap "Cold Water" position (blue mark) and then adjust the desired temperature.
WINTERIZING or LONG PERIOD OF UNUSED
1. Disconnect the water supply and disconnect the hose from the shower.
2. Put the faucet handle, wide open position "Hot Water" (red mark) and let the water run for several minutes to
purge the shower.
3. Disassemble the shower and store it in a safe place, dry and tempered place.
SPARE PARTS
Ref 104246 Shower spare parts kit (showerhead, mixer, quick connector)
The damage caused by salt water, frost, mechanical shock, excessive tightening or pressure
are not included under warranty.
Any signs of altering the tube material (crack, color change, deformation) require stopping and the
NOT101436 – ind B – 0613 BY AQUALUX
User manual SOLAR SHOWER
expertise of the shower by a professional.
3359190001241
EAN13 3660231350373
2/4