Télécharger Imprimer la page

Nicols TX DMX IP Manuel D'utilisation page 7

Publicité

User manual
Congratulations on the purchase of your new DMX TRANSMITTER. The TX DMX IP works with all
machines under DMX 512 protocol. The unit is electrically isolated between the input and the
output, it is equipped with PG9 connectors (3 pins) The internal transfer rate reaches 250 K,
transmission speed , Auto correction, and no possible disturbance. You can use 1 receiver 1
transmitter or 1 transmitter and a multitude of receiver. Several transmitters can be used in the
same place.
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the
contents to ensure that all parts are present, and have been received in good
condition. Notify the shipper immediately and retain packing material for inspection if any parts
appear damaged from shipping or the carton itself shows signs
of mishandling. Save the carton and all packing materials. In the event that a
fixture must be returned to the factory, it is important that the fixture be returned
in the original factory box and packing.
Safety Instructions
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance .
* Please keep this User Guide for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
*Always make sure that you are connecting to the proper voltage and that the line
voltage you are connecting to is not higher than that stated on decal or rear panel of
the fixture.
* Make sure there are no flammable materials close to the unit while operating.
* The unit must be installed in a location with adequate ventilation, at least 50cm
from adjacent surfaces. Be sure that no ventilation slots are blocked.
*Always disconnect from power source before servicing or replacing lamp or fuse
and be sure to replace with same lamp source.
* In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center.
Always use the same type spare parts.
* Don't connect the device to a dimmer pack.
* Make sure power cord is never crimped or damaged.
* Never disconnect power cord by pulling or tugging on the cord.
• Don't operate this device under 113° F ambient temperature conditions.
1.Technical specification
Power input
Fuse(internal)
Dimension
Weight
Puissance de transmission
Distance de transmission (champ libre)
Plan de fréquences
Antenne hélicoïdale SMA 100 mm – Gain élevé avec une longue distance de transmission
AC100~240V 50/60Hz
F0,9A 250V
210X170X70MM
0.7KG
20 DBm
300 m
2400 – 2524 Mhz
TX DMX IP
7

Publicité

loading

Produits Connexes pour Nicols TX DMX IP