Programing; Change The Admin Code - Pirnar 6279 Instructions D'utilisation

Ф KEYPAD OPERATING INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE CONNECTING THE KEYPAD TO THE
POWER SUPPLY!
After the door is installed, connection to the supply voltage of 12 V DC has to be carried out by a
competent person. When connected, the keypad will light up in blue.
The PIRNAR Art. 6279 keypad is very simple to use. When registering, each user chooses an op-
tional numeric code between 4 and 8 digits.
MARKINGS AND WARNING SYMBOLS:
The device has two parts: the keypad located in an easily accessible position, and the control module
located in a position inaccessible to the user. Access to this part requires the assistance of customer
service.
MAINTENANCE:
The device requires no special maintenance. Clean with non-aggressive cleaning agents or a damp
cloth.

PROGRAMING

a. CHANGE THE ADMIN CODE
The factory-set admin code is 1234. We recommend that you change it immediately to your chosen
admin code using the attached instructions (see diagram 1). You may choose any 4-8 digit number,
except for 1234.
MAKE SURE THAT YOU STORE THE NEW ADMIN CODE IN A SAFE PLACE!
diagram 1
Blue lightblau
1
Press and hold for 5 seconds
Pink flashing
2
Enter the admin code (1234) and press
Pink lightrosa
3
Enter the admin code (1234) again and press
Green flashing. Pink light
4
Enter the new admin code and press
Green flashing. Pink light
5
Enter the new admin code again and press
Green and 3x blue flashing
Press at anytime to restart the procedure
rosa
rosa
7