USRobotics 5436A Guide D'installation Rapide page 7

4. Slide the standard power plug for your country on to the power adapter.
Apply enough pressure to cause a click and firmly seat the plug. The power
adapter must be unplugged when you attach the plug.
5. Connect the included power adapter to the
server and plug the power adapter into a standard power outlet.
Step Two: Configure the Wireless USB Print Server
1. Verify you are logged on to your computer as an administrator. You must be
logged on as an administrator to ensure the software will be properly
installed.
2. Insert the USRobotics Installation CD-ROM.
3. Select
Setup Wizard
4. Select the Wireless USB Print Server from the list and click
Follow the on-screen instructions to configure the settings for the print
server. Make sure your enter the correct settings for your wireless network,
including SSID, security information, and network type (Infrastructure or
AdHoc).
5. Click .
Finish
6. When prompted to install the PTP (Peer-to-Peer) driver, click
click and follow the on-screen instructions.
Next
7. In the Printer Port Setup, select the printer and click
" If you do not see the printer, click
8. Select the printer from the
" If the printer doesn't appear, click
screen instructions.
9. Click .
Connect
" If you do not see an asterisk next to the port name in the Printer Port
Setup screen, click
shooting" section in this guide.
10. Click to complete the setup.
Close
North America
UK
and click .
Next
Refresh
Existing Printers
Add New Printer
. If it still doesn't appear, refer to the "Trouble-
Refresh
Europe
power port on the print
POWER
Next
.
Next
until the port name appears.
list.
and follow the on-
English
.
. Then,
Yes
3