GE Profile WPDH8850 Manuel D'utilisation Et D'installation page 7

8
9
10
11
12
Prewash
Prewash is an extra wash before
the main wash. Use it for heavily soiled
clothes or for clothes with a care label
that recommends prewashing before
washing. Be sure to add high-efficiency
detergent, or the proper wash additive
to the prewash dispenser.
Extra Rinse
Use an extra rinse when additional
rinsing is desired to remove excess dirt
and detergent from soiled loads.
Delay Start
You can delay the start of a wash cycle
for up to 24 hours. Press the DELAY
START button to choose the number
of hours you want to delay the start
of the cycle. Use the ▲ and ▼ (up and
down) arrows to find the desired delay
time; then press ENTER to select the
delay time. Finally, press the START
button after the desired cycle is
selected. The machine will count
down and start automatically
at the correct time.
Lock
You can lock the controls to prevent
any selections from being made. Or
you can lock or unlock the controls
after you have started a cycle.
Children cannot accidentally start
the washer by touching pads with
this option selected.
MY CYCLE
(on some models)
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin
speed and wash temp settings and
hold down the MY CYCLE button for
3 seconds. A beep will sound to indicate
the cycle has been saved.
To use your custom cycle, press
the MY CYCLE button before washing
a load.
To change the saved cycle, set
the desired settings and hold down
the MY CYCLE button for 3 seconds.
GEAppliances.com
The prewash feature will fill the washer
(adding the prewash detergent), tumble
the clothes, drain and spin. Then the
washer will run the selected wash
cycle.
NOTE: In some special cycles,
the prewash is selected automatically
as the default. You can modify this
selection at any time.
NOTE: In some special cycles, the extra
rinse is selected automatically as the
default. You can modify this selection at
any time. Some cycles have additional
rinses done automatically.
NOTE: If you forget to fully close
the door, a reminder signal will beep
reminding you to do so.
NOTE: If you open the door when the
delay is counting down, the machine
will enter the pause state. You must
close the door and press START again
in order to restart the countdown.
To lock the washer, press and hold
the LOCK button for 3 seconds.
To unlock the washer controls,
press and hold the LOCK button for
3 seconds. A sound is made to indicate
the lock/unlock status.
The control lock icon on the display will
light up when it is on.
NOTE: The POWER button can still be
used when the machine is locked.
NOTE: When using MY CYCLE,
wash options cannot be modified
after the cycle has been started.
NOTE: If you change wash options
with MY CYCLE before starting the cycle,
the MY CYCLE light will turn off and you
will be returned to the base cycle.
7