Table Des Matières - CAPspray GM3600 Manuel De L'utilisateur

Important Safety Information
haZaRD: GENERaL
Can cause severe injury or property damage.
PREvENTION:
• Read all instructions and safety precautions before operating
equipment.
• Follow all appropriate local, state, and national codes governing
ventilation, fire prevention, and operation.
• The United States Government Safety Standards have been
adopted under the Occupational Safety and Health Act (OSHA).
These standards, particularly part 1910 of the General Standards
and part 1926 of the Construction Standards should be consulted.
• Use only manufacturer authorized parts. User assumes all risks
and liabilities when using parts that do not meet the minimum
specifications and safety requirements of the pump manufacturer.
• All hoses, fittings, and filter parts must be secured before
operating spray pump. Unsecured parts can eject at great force
or leak a high pressure fluid stream causing severe injury.
• Before each use, check all hoses for cuts, leaks, abrasion or
bulging of cover. Check for damage or movement of couplings.
Immediately replace the hose if any of these conditions exist.
Never repair a paint hose. Replace it with another grounded high-
pressure hose.
• Do not kink or over-bend the hose. Airless hose can develop
leaks from wear, kinking and abuse. A leak can inject material
into the skin.
• Do not expose the hose to temperatures or pressures in excess of
those specified by manufacturer.
• Do not spray outdoors on windy days.
• Wear clothing to keep paint off skin and hair.
• Do not operate or spray near children. Keep children away from
the equipment at all times.
• Do not overreach or stand on an unstable support. Keep effective
footing and balance at all times.
• Use lowest possible pressure to flush equipment.
• Stay alert and watch what you are doing.
• Do not operate the unit when fatigued or under the influence of
drugs or alcohol.
• For electric units - Always unplug cord from outlet before
working on equipment.
• Do not use the hose as a strength member to pull or lift the
equipment.
• Do not lift by cart handle when loading or unloading.
© SprayTECH. All rights reserved.
operating the equipment. SavE ThESE INSTRucTIONS.
·
Read all safety information before
Table of contents
Safety Precautions ................................................................ 2-3
Introduction ............................................................................... 4
Preparation................................................................................ 5
Operation ................................................................................ 5-6
cleanup ..................................................................................... 6
Maintenance .............................................................................. 7
Troubleshooting ....................................................................... 7
Parts List ................................................................................. 20
Specifications
Maximum air input pressure ............ 115 PSI (0.79 MPa)
Maximum working pressure............. 3600 PSI (24.8 MPa)
Air connector .................................. QD Nipple
Material connector ........................... NPSM 1/4"
Filter, standard................................. 100 mesh (see chart on page
Length.............................................. 8.5" (216 mm)
Height .............................................. 9.8" (250 mm)
Weight ............................................. 1 lb. (420 g)
Reversible Tip Spray Gun ............... P/N 0524357
Flat Tip Spray Gun .......................... P/N 0524358
3
7 for available filter sizes)
English