AERMEC FCL Manuel De Fonctionnement page 13

BASIC OPERATION
TIPS ABOUT THE AUTOMATIC MODE
In AUTOMATIC mode, the temperature setting and
mode are automatically selected according to the room
temperature when the unit is turned on.
Modes and temperature settings
Automatic operation
Room Mode
temperature
at start
Below HEATING
21°C
From 21°C DEHUMIDIFICA-
to 24°C TION
From 24°C COOLING
to 26°C
From 26°C COOLING
to 28°C
Above COOLING
28°C
1
AUTOMATIC
2
2
5
3
1
3
4
The temperature can be changed in increments of
1°C within the range of 2°C higher to 2°C lower than
the temperature automatically determined by the air
conditioner.
The temperature can be set within the range 18 - 32°C.
Temperature
setting
4
23°C
AUTOMATIC
Room temperature
at start
24°C
In the DEHUMIDIFICATION mode, the fan speed is
pre-set to AUTOMATIC and cannot be changed.
25°C
5
26°C
Press the MODE button to select the operation
mode.
COOLING
HEATING
Press the ON/OFF button to switch on the unit.
The red indicator light on the unit will light up.
Press the TEMP. button to set the desired
temperature.
AUTOMATIC/
DEHUMIDIFICATION MODE
COOLING/
HEATING MODE
Press the FAN button to set the desired fan speed.
SOFT LOW
To switch off the unit, press the ON/OFF button
again.
The red indicator light on the unit will switch off.
IFCLFJ 1102 - 4528570_02
DEHUMIDIFI-
CATION
HIGH
13