Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation of Your Appliance
Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded.
To level your appliance, adjust the legs at the front of the appliance.
NOTE: TO AVOID VIBRATION, THE APPLIANCE MUST BE LEVEL
Allow 5 inches of space between the back and side of the appliance, which allows the proper air
circulation to cool the compressor.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.)
Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator requiring more frequent defrosting of the appliance.
Plug the appliance into an exclusive properly installed – grounded wall outlet. Do not, under any
circumstances, cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an authorized
service center.
To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these
basic precautions.
IDENTIFICATION DIAGRAM
Freezer
compartment
Thermostat dial
Plastic coated
shelves
Crisper
Can Holder
Adjustable feet
Hinges
Freezer door
Magnetic gasket
Tall Bottle rack
Refrigerator
door
Publicité
Table des Matières
