Viking P2WG2 Manuel D'utilisation page 19

Troubleshooting
•
Is the ice dispenser stalling while dispensing "crushed" ice? Change the ice button from
"crushed" to "cubed." If cubed ice dispenses correctly, depress the button for"crushed" ice and
begin dispensing again.
•
Has the dispenser lever been held in too long? Ice will stop dispensing when the arm is held in
too long. Wait 3 minutes for dispenser motor to reset before using again.
The water dispenser will not operate properly
Check the following:
•
Is the freezer door closed completely?
•
Is the water shutoff valve not turned on, incorrectly installed or clogged?
•
Is the water line connected at the source?
•
Is there a kink in the home water source line?
•
Has the water system not filled? The water system needs to be filled the first time it is used.
•
Is the refrigerator connected to a cold water line with water pressure of at least 30 psi (207 kPa)? The
water pressure to the home determines the flow from the dispenser.
•
Is there a water filter installed on the refrigerator? The filter may be clogged or incorrectly in-
stalled.
•
Is a reverse osmosis water filtration system connected to your cold water supply? See "Water Sup-
ply Requirements" in the Installation Instructions.
Water is leaking from the dispenser
Check the following:
•
Is the glass not being held under the dispenser long enough?
•
Has the water system been flushed since installation or changing filters?
The dispenser water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
•
Has the refrigerator been newly installed or a large amount of water recently dispensed? Allow 24
hours for the refrigerator to cool completely.
•
Has water not been recently dispensed? The first glass of water may not be cool. Discard the first
glass of water.
19