Haussmann Xpert DP1200 Manuel De L'utilisateur page 19

WARNING
The drill press is designed to be safely assembled by at
least two people working together.
INSTALL COLUMN SUPPORT
Refer to Figure 2
• Place the base on the floor or a bench.
• Place column on the base.
• Align the holes and secure the column on the base with
4 long hex bolts and washers.
Figure 2
Column
Base
TABLE INSTALLATION
Refer to Figure 3 and 4
• Locate the retaining ring on the column.
• Loosen the set screw on the retaining ring and remove
both the rack and ring from the column.
• Locate the table assembly. Place the rack inside the
table assembly bracket. Engage the rack's teeth with the
pinion gear on bracket.
• Slide table assembly over the column.
• Position the rack so its end sits inside the beveled
column flange.
• Replace the retaining ring over the column and secure
with set screw.
• Check to see the top of rack is secured inside the
beveled edge of retaining ring. And the table assembly
can rotate around the column smoothly. Adjust the
retaining ring if necessary.
• Align and attach the crank handle to the shaft on the
table assembly. Secure with screw.
• Thread and clamp tight the table locking handle to
secure the table assembly on the column.
Figure 3
Figure 4
Hex Bolt
Table
Assembly
DRILL PRESS HEAD INSTALLATION
Refer to Figure 5
• Position and slide the head over the column.
• Carefully rotate the head on the column so it is aligned
with the base.
• Secure the drill press head with two set screws,
using the hex wrench.
18
Pinion Gear
Table
Assembly
Retaining
Ring
Column
Base
Set Screw
Table Assembly
Bracket
Locking
Handle
Crank
Handle
Rack