Spécifications - ICON ProAudio MobileR Dyna Guide De L'utilisateur

Spécifications
ADC:
Dynamic Range: ............................................. 116dB, A-weighted
Signal-to-Noise Ratio:..................................... -116dB, A-weighted
THD+N Ratio: ................................................. -108dB, -1dBFS
DAC:
Dynamic Range: ............................................. 127dB, A-weighted
Signal-to-Noise Ratio:..................................... -127dB, A-weighted
THD+N Ratio: ................................................. -120dB, 0dBFS
Mic Input(XLR, Balanced):
Frequency Response: .................................... 20Hz to 20kHz (+/-0.1dB)
Noise EIN: ...................................................... <-120dB
Input Impedance: ............................................ 1.8K Ohms
Gain Range: ................................................... -6dB~+46dB
Maximum Input Level: .................................... +9dBu
Instrument Input(6.35mmTRS, Unbalanced):
Frequency Response: .................................... 20Hz to 20kHz (+/-0.1dB)
Input Impedance: ............................................ 390K Ohms, typical
Gain Range: ................................................... +6dB~+45dB
Maximum Input Level: .................................... +9dBu
Line Outputs 1/2 (Stereo, Unbanced):
Frequency Response: .................................... 20Hz to 20kHz (+/-0.1dB)
Nominal Output Level: .................................... +6dBu, typical
Maximum Output Level:.................................. +10dBu
Output Impedance: ......................................... 150 Ohms
Load Impedance: ............................................ 600 Ohm minimum
Headphone Outputs: (Stereo, Unbanced):
Frequency Response: .................................... 20Hz to 20kHz (+/-1dB)
Maximum Output Level:.................................. +9dBu, typical
Output Impedance: ......................................... 10 Ohms
Load Impedance: ............................................ 32 to 600 Ohms
38