Hardware Installation - Acksys AirBox V2 LTE Guide D'installation Rapide

1. Plug the antennas in
Connect the supplied WiFi/LTE antennas on the connectors. Be aware of
RF antennas connectors' difference between WiFi and LTE (See connectors
section).
Don't mix up cellular antennas and WiFi antennas. WiFi
antennas have RP-SMA male connectors (with a hole at
the center) whereas cellular and GNSS antennas have
SMA male connectors (with a pin at the center).

Insert the SIM card (s)
The product is designed to accept SIM cards in Nano-SIM format (the
smallest format). Check the compatibility of your SIM card and follow these
steps:
a- Press lightly with a non-metallic pointed object with a diameter of
less than 2mm on the pin on the right side of the SIM drawer.
b- Place the Nano-SIM card in the drawer as shown below.
c- Insert the drawer in its original location in the direction indicated
below until the "Click".
2. Connect the power supply

The product has 3 power sources, 2 DC's PWR1 and PWR2 on the 5
ways terminal block and one PoE through LAN 2 port.

See the
supply.

The device has no ON/OFF switch. It turns-on automatically when
power is applied. Check LEDs PWR1 and PWR2:

PWR1 LED is ON if power supply 1 (PWR1) or PoE source is ON.

PWR2 LED is ON if power supply 2 (PWR2) is ON.
The Diag LED stays red for around 60 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3. Connect the Ethernet cable

If you want to use the product in PoE mode, connect the PoE source
onto LAN2. Do not connect simultaneously PWR1/PWR2 power
supplies.

Plug the provided Ethernet cable to the LAN1 or LAN2 connector.

Check that the corresponding Link/Act LED turns ON at that point.

HARDWARE INSTALLATION

Power Supply section about the characteristics of the power
-2-
the