Varan HZS-550 Manuel D'utilisation page 9

3). Fill the pump with water to make sure that the pump body, filter basket, pipes and other connectors
are not leaking. Tighten or loose the screws with hands, or tolls if necessary.
4). Make sure the pumps are working with water in any case.
Start up
4.
Start electrically the pump only when the suction and discharge pipes are connected to the corre- sponding
inlets and outlets. Do not tighten or loose the screws when the pump is working. Please cut off power and
contact with your distributors in case the pump can not working. The pump is not self priming and must be
completely filled to prevent the pump from running dry.
MAINTENANCE AND CLEAN
INSTRUCTIONS
Our pumps do not require any specially maintenance or programming. Regular clean the debris in the filter of
pumps, avoid block the inlet pipes and damage the pumps. In case the pumps will be idle for a long period of
time. It is recommended to disassemble, clean and store in a dry, well-ventilated place.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
HZS-550
HZS-750
T: 00352/26908036 – F: 00352/26908040