Reverse Function; Setting Dip Switches - Fanaway LD-0003-10/WH/GS/E27 Guide D'installation

REVERSE FUNCTION

Your ceiling can operate either in fan mode or reverse fan mode.
SUMMER Mode: The reverse switch shall be in "down" (SUMMER) position to make the fan rotate in the
anticlockwise direction. The airflow will be directed downwards, for cooling in summer.
WINTER Mode: The reverse switch shall be "up" (WINTER) position to make the fan rotate in clockwise
direction. The airflow will be directed upwards, for energy conservation in winter.
HOW TO USE THE FAN/LIGHT WITH REMOTE CONTROL

SETTING DIP SWITCHES

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each
fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.
The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the
transmitter are in the battery compartment. Fig. 5.
NOTE: Ensure that the power to the supply wires has been turned off before setting the code.
NOTE: Before you change the DIP switch settings, make sure the battery is not connected to the transmitter.
Figure 5 Figure 6
Change the position of the DIP switches in the remote transmitter and the receiver. Make sure that the DIP
switches match in the remote receiver and transmitter. If they don't match, the transmitter will not function. Fig.
6
7