Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
17.2.3 Lifting the Table
Due to micro leaks in the hydraulic system, the table lowers slowly but gradually if
left in the same position for a longer period of time.
The machine is equipped with a hydraulic pump. The load is lifted by levering the foot lever (9).
Apply the brakes and then pump with the foot lever
until the table has reached the desired height.
Once the maximum height has been reached, the foot lever remains ineffective and the table
even sinks slightly.
17.2.4 Lowering the Table
Keep your hands and feet away from the scissor mechanism!
The lowering speed correlates with the weight of the load. You can slowly lower the table by
briefly pressing the lowering handle (11) several times in succession and releasing it immediately.
Do not fully pull the lowering lever. Otherwise the load will drop too quickly.
18.2.5 Activating the safety position / fixing the table height.
When folding down the strut, hold it firmly and carefully release it from the holder
and carefully lower it to the stop to prevent your hands from being clamped.
After folding down the struts (1) onto the frame, the table can be lowered to the securing
position, but no further. To lower it to the minimum height, the table must be raised again, the
struts folded back into the holder (2).
17.2.5 Driving with Load
Do not use the machine on ramps and inclines!
Move the load as low as possible above the floor, taking ground clearance into account.
Pay attention to obstacles on the carriageway.
17.2.6 Parking
Always activate the brakes when the table is not in use, in order to avoid accidental machine
movements.
HOLZMANN MASCHINEN GmbH
NOTICE
WARNING
CAUTION
WARNING
www.holzmann-maschinen.at
OPERATION
SHT150XF | SHT300XF | SHT350XXF
23
Publicité
Table des Matières
