Thermo Soles S Mode D'emploi page 4

®
Unpack the THERMO SOLES and adapter.
The THERMO SOLES are not charged and must be fully charged for 8 hours
before first use. The ON/OFF switch, located on the back side of the soles, is
protected by a soft plastic cap. Open the cap and set the ON/OFF switch to the
left "OFF" position (towards the direction of the socket.) If switched to the "ON"
position, a red LED light will appear for 2 minutes next to the switch, indicating that
the soles are activated and heating! The soles will NOT be charged in this position!
Plug in the end of the adapter cables to both of the THERMO SOLES sockets and
then plug in the adapter to charge the soles. Both soles must always be charged at
the same time!
After the initial charge, regular charging time is approximately 2 hours. The LED
light on the adapter (not the soles!) turns to red during loading and then to green
after loading is completed! After the soles are fully charged, unplug the adapter and
the soles. The THERMO SOLES are now ready to be used!
The high-quality 900mAh LI-ION Polymer Batteries (no memory effect!) can not be
damaged by frequent charging and can be re-charged approximately 500 times!
When using the THERMO SOLES, turn both switches to the right "ON" position
before inserting the soles into your shoes. The red LED light on the soles will light
up for approximately 2 minutes, indicating that the soles are turned ON! Put back
the protective cap by first inserting the peg into the charging plug on the left and
then cover the ON/OFF switch on the right.
If needed, remove any existing in-soles from your shoes or boots in order to
guarantee a perfect fit for your THERMO SOLES. The tabs at the end of the soles
will protect the plug and ON/OFF switch and also will help you to easily remove the
soles again from your shoes or boots after use.
The integrated thermostats in the soles will be activated after turning the switch
to the "ON" position. The "Heating Mode" will automatically be activated after the
temperature drops below 31°C and will be de-activated again when the tempera-
ture reaches 41°C.
Please note that the red LED on the soles will only light up when the soles are in
the "Heating Mode" (except when turning the soles on)! The heating position is
approximately 2 minutes (and the LED light is red for 2 minutes). Then the soles are
on stand-by measuring the temperature. The LED light will turn off again as soon
as the temperature of 41°C has been reached and will turn on again when the
temperature has fallen below 31°C!
The maximum heating time, depending on the outside temperature and quality of
your shoes or boots, is approximately 8 hours!
Remove the THERMO SOLES after each use and turn "OFF" the power! Re-
charge the soles before your next use!
STORAGE:
For best performance it is recommended not to fully charge the batteries if the
soles are not being used for a longer period of time! Charge for 20 minutes only
and after 3 months charge the batteries again for about 20 minutes! Charge the
batteries completely before using the soles again during the following season.