Guardian G1-301DPX1 Mode D'emploi Et Garantie page 3

ASSEMBLY:
1. Remove contents from box.
Depress pushbuttons and insert
bucket frame section into first
arm. The pushbuttons will
snap into place when frame
in securely in place. Note:
Make sure the back of the
bucket frame (the side with the
backrest receptacles) is on the
same side as the back of the
armrest section.
2. Repeat for second arm section.
3. Insert backrest into backrest
receptacles in commode bucket
frame. The pushbuttons will
snap into place when secure.
4. Align the padded or unpadded
toilet seat clamps onto the rear
frame rail. (Both clamps should
sit outside the pail brackets).
Push down on seat until clamps
snap firmly into place. To
remove, grasp the back of the
seat and lift.
5. Install commode bucket by
dropping into bucket frame. Lift
bucket from frame to remove for
emptying and cleaning.
LEG HEIGHT ADJUSTMENT
Before using the commode, make sure
all legs are set to the same preferred height.
1. To adjust leg height, depress pushbutton
and slide each leg to the desired height
by aligning with proper holes and letting
the pushbutton snap into the correct hole.
(Figure 1)
2. Repeat until all legs are adjusted to the
Figure 1
G1-301DPX1 (PIC-00244)
REVISED: 06/21/2021