Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
7. CUTING FREQUENCY CONTROL
Use to control de cutting frequency ( low pass filter ) of subwoofer. Set from 40Hz to 300Hz
8. AC SOCKET + FUSE
Before to connect the ac cord on this socket, make sure that the available voltage is not higher than stated at the end of this
manual
The ac fuse is integrated on the power connector. It's used to avoid power supply default on speaker. if the ac cord is connected
and power switch push on the position on but speaker doesn't work, please check the fuse. if the fuse is out of order, replace it
by fuse with same size and same value.
9. POWER SWITCH
This switch is used to power on or power off the K212A subwoofer
TECHNICAL SPECIFICATIONS
Woofer :
2x12'' ( 2x31cm )
Frequency response :
38Hz – 500z
Sensitivity :
102dB
RMS power :
900W
Max power :
1800W
Line input :
Combo XLR-Jack
Line link output :
XLR
Power supply :
220-240VAC, 50/60Hz
Dimensions :
605x580x576mm
Weight :
55Kg
1. LEFT INPUT
Connect on this socket ( Combo XLR - Jack ) the left output of a line level
device as cd player, DVD player, mixer,....
2. RIGHT INPUT
Connect on this socket ( Combo XLR - Jack ) the right output of a line l
level device as cd player, DVD player, mixer,....
3. RIGHT LINK OUTPUT
This ouput is same signal as the LINE input. Connect this output to the
right input of an other activ speaker or to a power amplifier
4. LEFT LINK OUTPUT
This ouput is same signal as the LINE input. Connect this output to the
left input of an other activ speaker or to a power amplifier
5. SIGNAL POLARITY SELECTOR
Use this switch to inverse signal polarity of input signal
6. MASTER VOLUME
This control is used to adjust level control of the subwoofer .
.
Publicité
